研究与技术人员

王京阳 博士 研究员

  • [75] Z. J. Lin, M. J. Zhuo, Y. C. Zhou, M. S. Li and J. Y. Wang, “Structural characterization of a new layered-ternary Ta4AlC3”, J. Mater. Res. 21, 2587-2592 (2006)
  • [76] Y. C. Zhou, D. T. Wan, Y. W. Bao and J. Y. Wang, “In situ processing and high-temperature properties of Ti3Si(Al)C2/SiC composites”, Int. J. Appl. Ceram. Technol. 3, 47-54 (2006)
  • [77] J. Y. Wu, Y. C. Zhou, and J. Y. Wang, “Tribological behavior of Ti2SnC particulate reinforced copper matrix composites”, Mater. Sci. Eng. A 422, 266-271 (2006)
  • [78] H. B. Zhang, Y. C. Zhou, Y. W. Bao, M. S. Li and J. Y. Wang, “Intermediate phase in synthesis of Ti3SiC2 and Ti3Si(Al)C2 solid solutions from elemental powders”, J. Eur. Ceram. Soc. 26, 2373-2380 (2006)
  • [79] Z. J. Lin, Y. C. Zhou, M. S. Li and J. Y. Wang, “Hot corrosion and protection of Ti2AlC against NaSO4 salt in air”, J. Eur. Ceram. Soc., 26, 3871-3879 (2006)
  • [80] Z. J. Lin, M. J. Zhuo, Y. C. Zhou, M. S. Li and J. Y. Wang, “Microstructures and adhesion of the oxide scale formed on titanium aluminum carbide substrates”, J. Am. Ceram. Soc. 89, 2964-2966 (2006)
  • [81] Z. J. lin, M. J. Zhuo, Y. C. Zhou, M. S. Li and J. Y. Wang, “Microstructures and theoretical bulk modulus of layered ternary tantalum aluminum carbides” J. Am. Ceram. Soc. 89, 3765-3769 (2006)
  • [82] Z. J. Lin, Y. C. Zhou, M. S. Li and J. Y. Wang, “Improving the NaSO4-induced corrosion resistance of Ti3AlC2 by pre-oxidation in air”, Corrosion Science, 48, 3271-3280 (2006)
  • [83] X. G. Liu, X. W. Wang, J. Y. Wang and H. Y. Zhang, “Effect of interstitial hydrogen on cohesive strength of Al grain boundary with Mg segregation”, J. Mater. Sci. Technol. 22, 135-138 (2006)
  • [84] J. Y. Wang, Y. C. Zhou, Z. J. Lin, “First-principles elastic stiffness of LaPO4 monazite”, Appl. Phys. Lett. 87, 051902 (2005)
  • [85] J. Y. Wang, Y. C. Zhou, Z. J. Lin, F. L. Meng and F. Li, “Raman active phonon modes and heat capacities of Ti2AlC and Cr2AlC: first-principles and experimental investigations”, Appl. Phys. Lett. 86, 101902 (2005)
  • [86] J. Y. Wang, Y. C. Zhou, Z. J. Lin and T. Liao, “First-principles investigation on chemical bonding and bulk modulus of the ternary carbide Zr2Al3C5”, Phys. Rev. B 72, 052102 (2005)
  • [87] X. G. Liu, X. W. Wang, J. Y. Wang and H. W. Zhang, “First-principles investigation of Mg segregation at Σ = 11(113) grain boundary in Al”, J. Phys.: Condens. Matter 17, 4301-4308 (2005)
  • [88] F. L. Meng, Y. C. Zhou and J. Y. Wang, “Strengthening of Ti2AlC by substituting Ti with V”, Scripta Mater. 53, 1369-1372 (2005)
  • [89] Z. J. Lin, Y. C. Zhou, M. S. Li and J. Y. Wang, “In-situ hot pressing/solid-liquid reaction synthesis of bulk Cr2AlC”, Z. METALLKD. 96, 291-296 (2005)
  • [90] J. Y. Wu, Y. C. Zhou, J. Y. Wang, W. Wang and C. K. Yan, “Interfacial reaction between Cu and Ti2SnC during processing of Cu-Ti2SnC composite”, Z. METALLKD. 96, 1314-1320 (2005)
  • [91] E. D. Wu, J. Y. Wang, H. B. Zhang, Y. C. Zhou, K. Sun and Y. J. Xue, “Neutron diffraction studies of Ti3Si0.9Al0.1C2 compound”, Mater. Lett. 59, 2715-2719 (2005)
  • [92] J. Y. Wang and Y. C. Zhou, “Dependence of elastic stiffness on electronic band structure of nano-laminate M2AlC (M =Ti, V, Nb and Cr) ceramics”, Phys. Rev. B 69, 214111 (2004)
  • [93] J. Y. Wang and Y. C. Zhou, “Polymorphism of Ti3SiC2 ceramic: first-principles investigations”, Phys. Rev. B 69, 144108 (2004)
  • [94] J. Y. Wang and Y. C. Zhou, “Ab initio elastic stiffness of nano-laminate (MxM’2-x)AlC (M and M’=Ti, V and Cr) solid solution”, J. Phys.: Condens. Matter 16, 2819-2827 (2004)
  • [95] R. Z. Huang, Y. M. Wang, J. Y. Wang and Y. C. Zhou, “First-principles investigation of the stability and electronic structure of ZrV2Hx (x=0.5,1, 2, 3, 4, 6 and 7)”, Acta Mater. 52, 3499-3506 (2004)
  • [96] X. W. Wang, J. Y. Wang, P. Wu and H. W. Zhang, “The investigation of internal friction and elastic modulus in surface nanostructured materials”, Mater. Sci. Eng. A 370, 158-162 (2004)
  • [97] Y. C. Zhou, H. B. Zhang, M. Y. Liu, J. Y. Wang and Y. W. Bao, “Preparation of TiC free Ti3SiC2 with improved oxidation resistance by substitution of Si with Al”, Mater. Res. Innov. 8 , 97-102 (2004)
  • [98] X. W. Wang, J. Y. Wang, L. Y. Xiong, G. Liu, “Defect characteristics in the surface and nanocrystallined material treated by high-energy shot peening”, Materials Science Forum, Vol. 445-6, 210-212 (2004)
  • [99]J. Y. Wang and Y. C. Zhou, “First-principles study of equilibrium properties and electronic structure of Ti3Si0.75Al0.25C2 solid solution”, J. Phys.: Condens. Matter 15, 5959-5968 (2003)
  • [100]J. Y. Wang and Y. C. Zhou, “Ab initio investigation of the electronic structure and bonding properties of the layered ternary compound Ti3SiC2 at high pressure”, J. Phys.: Condens. Matter 15, 1983-1991 (2003)